GSM Gate Opener is an electronic that links to a GSM module, supplied with it. The purpose of this device is to be installed in parallel of the low voltage opening button of an electric gate to enable it to be opened by means of a GSM phone. It has a relay whose contact has to be connected in parallel with the button which opens the gate. It has a White List of numbers who are enabled to open the phone, up to 64. When the GSM Gate Opener receives a call it reads the caller ID then drops the call. If the calling number is in the list the gate will open otherwise if the number is unknown or withheld the caller is ignored. Advantages of GSM Gate Opener Safe: nobody can clone your phone as easily as they can do with a standard remote control Flexible: you can add or remove anybody number in a minute with an SMS Cheap: you don't need to buy a remote control for each member of your family Convenient: no matter if you change car, or if you have different gates to open. Your phone will always be with you all the times your remote controls were somewhere else!

To install the GSM Gate Opener you need to connect the 2 wires of the relay contact in parallel with the gate opening button or auxiliary contacts. The relay contact can stand 48V 0.5A maximum, this is enough for its operation but don't try to switch higher voltages or currents. Connect the yellow wires to these contacts.

The GSM Gate Opener is powered by means of 12 to 24 VDC supply. This is usually supplied by your existing controller. Check there are low voltage contacts on the controller you can use to power this unit and is able to stand 0.5 Amps. We can supply an AC adapter if required although 90% of controllers provide auxiliary power. Connect the red to the positive supply and black wire to the negative.

If you need to install the device in a place with little signal, you may consider using an external antenna which can be supplied as an optional extra purchased separately with 2 meters of cable.

You can now insert the SIM card into the unit by gently applying pressure to both sides of the SIM card holder and pulling the holder out. Place SIM card into the tray and gently push back all the way until it stops. Switch the power onto the unit and after the green light flickers for a few seconds it will then settle to one flash every 3 or 4 seconds showing it is logged onto the GSM network and is in normal operation.

Don’t use a mobile phone battery charger! Most of them rely on the phone battery and are unable to supply the power needed. You should install the GSM Gate Opener in a place where there is GSM signal strong enough from the network you want to use. Check it with a normal phone before proceeding with the installation.

If you need to install the device in a place with little signal, you may consider using an external antenna which can be supplied as an optional extra purchased separately with 2 meters of cable.

You can now insert the SIM card into the unit by gently applying pressure to both sides of the SIM card holder and pulling the holder out. Place SIM card into the tray and gently push back all the way until it stops. Switch the power onto the unit and after the green light flickers for a few seconds it will then settle to one flash every 3 or 4 seconds showing it is logged onto the GSM network and is in normal operation.

NEW - GSM Gate openers Safe: nobody can clone your phone as easily as they can do with a standard remote control Flexible: you can add or remove anybody number in a minute with an SMS Cheap: you don't need to buy a remote control for each member of your family Convenient: no matter if you change car, or if you have different gates to open. Your phone will always be with you all the times your remote controls were somewhere else!

If you require any help please fill in the form below.       Comments Contact details name tel Post Code: (UK Postcode) email (E-mail)   Products of interest access control options   select ART - articulated arm ECO - Ram type LYN - Ram type SCS - Ram type 24 Volt SUB - Underground SLY - Sliding gate select Audio Intercom kits Combined Intercom/codelock kits Combined Video/intercom kits Combined Video/intercom/codelock kits Wireless Access Control Proximity and Swipe Card Reader kits   If you require assurance that you are buying the correct system. Please fill in the boxes below and we will gladly offer you some guidance. Please enter your measurements in mm.   mm mm mm mm mm   What are the gates made of? ie. timber,metal Which way do the gates open? select Inward (Towards property) Outwards (Away from property) What is the driveway surface? ie. gravel, tarmac, concrete Is this a domestic or commercial site ? select Domestic Commercial Approximately how many times will the gate open per day? select Up to 15 15 to 30 30 or more Is this a single user property or multi-user? select Single User Multi User

Automatic Electric Gate Comparisons
	from	Gate Wing Size (M)	<2.0	3	3.5	4	5	7
ECO 300	£229	Ram Motor
LYN 300	£279	Ram Motor
LYN 300 24 volt fast openers	£479	Ram Motor
SCS 300	£329	Ram Motor
SCS300 24Volt Fast Openers	£499	24Volt Motor
ART 300	£385	Articulated Swing Gate Opener
ECO 400	£295	Ram Motor
SUB 300	£385	Underground Gate Opener
Hydraulic BFT R kit	£745	Hydraulic Underground Kit
LYN 400	£329	Ram Motor
LYN 400 24Volt Fast Openers	£479	24Volt Motor
Hydraulic BFT Arm	£644	Hydraulic Arms
SLY/BFT Sliding Gates Opener	£339	Sliding Gate Opener	Upto 12 Metres

The PF6000Lux Automatic Raise Arm Barrier from Parking Facilities is designed to offer long term reliability, efficient operation and durability. It incorporates an integral 3 phase inverter driven motor and gearbox drive which provides a smooth consistent operation (single phase supply). It is controlled by a Programmable Logic Controller, which can be programmed to suit any access control requirements. It is available with arm lengths up to 6.0 metres (or 7.0 metres with counterweights). DOWNLOAD PDF NEW CALL FOR DETAILS